GSF3016HN
Owner’s Manual
12
Fully Assembled View
Step 13 (Rotisserie kit assembly. Option)
a) Insert two forks (KD), balance block (KF)
and roller (KE) into shaft (KC) in sequence.
Step 14 (Rotisserie motor installation. Option)
a)
Take two pre-installed screws on motor
support (KB) apart.
b)
Align the holes on the motor support (KB)
with the hole on the left side wall of firebox.
c)
Insert one bolt, one flat washer, on spring
washer and one nut into each drilled hole
and tighten by screw driver provided.
d)
Install rotisserie motor (KA) by insert the
slot on it into the motor support.
e)
Insert the shaft on fork side into the motor.
f)
Move the roller and put it into the slot on right
side wall of the firebox.
g)
Tighten the screw on roller by hand.
Note: Make certain the shaft will be not pulling
out from the motor during operation.
Left Side
Right Side
