GPF2414C
Owner’s Manual
14
Checking for Leaks
1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2. Make sure control knobs are in the “OFF” position.
3. Spray some solution on the tank valve up to the regulator connection.
(See diagram to right.)
4. Inspect the solution at the connections for bubbles. If no bubbles appear, the connection is secure.
5. If bubbles appear, you have a leak. Go to step 6.
6. Disconnect the regulator from the tank and reconnect. Make sure the connection is secured.
7. Retest with solution.
8. If you continue to see bubbles, replace the cylinder.
Lighting Your Grill
Danger:
Failure to open lid while igniting the grill’s burners or not waiting five minutes to allow gas to clear if the grill does not
light, may result in an explosion, which could cause serious bodily injury or death.
WARNING
: Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible
bodily injury.
Main Burner
1. Open lid while lighting burners.
WARNING
: Attempting to light the burner with the lid closed may cause an explosion. Make` sure there are no
obstructions of airflow to the gas unit. Spiders and insects can nest and clog the burner/venturi tube at the orifice. A clogged
burner tube can lead to a fire beneath the appliance.
2. All valves must be in the “OFF” position.
3. Open cylinder valve.
4. Ignite only the burners you wish to use.
Press and turn the burner to “HIGH” then press the igniter button immediately. The burner should light in 3-5 seconds.
(1) If ignition does not take place, press the igniter button 2 to 3 times.
(2) If ignition still does not take place, turn the burner control knob to the “OFF” position. Wait 5 minutes with lid open for the gas
to clear and repeat the lighting procedure
5. After burner ignites, repeat the same procedure with any other burner desired.
6. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1. Remove the cooking grate from the burner you wish to light.
2.
Light a match by inserting it into the end of a lighting stick.
3. Once lit, place the flame through the hole on grill body to reach the burner ports.
(See diagram to right).
4. Press the valve knob and rotate it counter clockwise to the ‘’HIGH’’ position. The
burner should light immediately. If more than one burner is desired, repeat the
same procedure for the adjacent burner and continue in sequence until all desired burners are lit.
5. Adjust burners to the desire cooking temperature.
Precautions
1. After lighting, observe the burner flame. Make sure all burner ports are lit.
2. If the burner flame goes out during operation, immediately turn the gas “OFF”.
Open lid to let the gas clear for at least 5 minutes before re-lighting.
3. Before cooking on the grill for the first time, operate the grill for approximately 15 minutes with the lid closed and the gas
turned on “HIGH”. This will “heat clean” the internal parts and dissipate odor from the manufacturing process and painted
finish.
4. Clean the grill after each use. DO NOT use abrasive or flammable cleaners. This may damage parts of the grill and cause a
fire.
