GPF2414AE
Instruction Manual
16
DANGER:
To prevent fire or explosion hazard when testing for a leak:
1. Always perform the “leak test“ below before lighting the grill and each time the cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use grill until all leaks have been stopped. If you are unable to stop a leak, disconnect the propane supply, call for gas
appliance service or your local propane gas supplier.
Checking for Leaks
1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2. Make sure control knobs are in the “OFF” position.
3. Spray some solution on the tank valve up to the regulator connection.
(See diagram to right.)
4. Inspect the solution at the connections for bubbles. If no bubbles appear, the connection
is secure.
5. If bubbles appear, you have a leak. Go to step 6.
6. Disconnect the regulator from the tank and reconnect. Make sure the connection is tight and secured.
7. Retest with solution.
8. If you continue to see bubbles, replace the cylinder.
Lighting Your Grill
DANGER:
Failure to open lid while igniting the grill’s burners or not waiting five minutes to allow gas to clear if the grill does not light, may
result in an explosion, which could cause serious bodily injury or death.
WARNING:
Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily injury.
Lighting Main Burner
1. Open
lid while lighting burners.
WARNING:
Attempting to light the burner with the lid closed may cause
an explosion. Make sure there are no obstructions of airflow to the gas unit. Spiders
and insects can nest and clog the burner/venturi tube at the orifice. A clogged burner
tube can lead to a fire beneath the appliance.
2. All valves must be in the “OFF” position.
3. Open
cylinder
valve.
4. Push and turn the control knob the “HIGH” position. (see diagram to right).
5. Press the electronic pulse igniter button and hold for 3-5 seconds to light burner.
6. If the burner still does not light in 5 seconds,turn the control knob to the “OFF” positon,wait 5 minutes and repeat the
lighting procedure.
7. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the Main Burners
1. Light a match by inserting it into the end of a lighting stick.
2. Once lit, place the flame through the hole on grill body to reach the burner ports.
(see diagram to right).
3. Press the valve knob and rotate it counter clockwise to the ‘’HIGH’’ position. The
burner should light immediately. If more than one burner is desired, repeat the
same procedure for the adjacent burner and continue in sequence until all desired
