W W W . B B K P E R F O R M A N C E . C O M
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
UPDATED LAST: March 2018
STEP 1
Disconnect the negative battery terminal and remove the air intake hose from
the throttle body.
STEP 2
Remove the 2 EGR tube bolts on the driver’s side of the plenum.
STEP 3
Remove the throttle cable bracket bolts and disconnect the throttle and cruise
control cables from the throttle body. Disconnect the electrical and vacuum
connections that attach to the plenum and throttle body.
STEP 4
Remove the 5 mounting bolts that attach the plenum to the manifold and
remove the throttle body/plenum assembly from the vehicle.
STEP 5
Determine the PCV fitting your application requires and install into the plenum.
NOTE!!! Install the PCV fitting before installing the IAC Valve. 1996-01 uses the
small PCV Fitting. 2002-04 uses the larger PCV Fitting.
STEP 6
Install the IAC valve using the supplied gasket and original bolts.
STEP 7
Inspect the plenum to lower manifold gasket, be sure to wipe any debris from
the mating surfaces then install the throttle body/plenum assembly onto the
intake manifold using the supplied hardware.
NOTE!!! For this installation you will only use 4 of the 5 mounting hole on the
intake manifold.
STEP 8
Re-establish the electrical and vacuum connections. Attach the throttle cable
and cruise control cable to the throttle intake and attach the bracket to the
throttle intake using supplied hardware.
STEP 9
Re-connect the EGR tube using the supplied gasket and original bolts.
Re-connect the air intake hose and the negative battery terminal.
