background image

SPECIFICATIONS

Model: BZCAP30 

3 Farad TRIANGLE

Hybrid Super Capacitor 

With Red Digital Voltage Display, Blue Flash LED, Blue Led Ring

Capacitance .................................……......3,000,000 micro farad
Working Voltage ...............................…….….. 21DC 
Surge Voltage .......................................……… 24DC 
E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25°C 
Capacitance Tolerance------------------------ ± 10% 

DETAILED FEATURES:

a)

4 digits hi-end red light display DC voltage meter that can measure 0.1 DCV range. 

b)

Reverse pole connecting PCB buzz warning function. If the capacitor is connected
incorrectly by reversing the positive and negative wires during the installation
process the PCB will issue a 45 second noise to warn you.

c)

Hi-end platinum plated 100% brass solid parts and chrome plated metal cover 

d)

Over voltage limit and low battery voltage limit warning. When the system voltage
peeks over 17.5 DCV or LESS than 10 DCV. The buzzer on the PCB will issue an 
audible noise warning.

e)

Multiple small capacitance capacitors linked to provide the lowest inner E.S.R. and
largest moment discharge power. 

1

Summary of Contents for BZCAPT30

Page 1: ...Reverse pole connecting PCB buzz warning function If the capacitor is connected incorrectly by reversing the positive and negative wires during the installation process the PCB will issue a 45 second noise to warn you c Hi end platinum plated 100 brass solid parts and chrome plated metal cover d Over voltage limit and low battery voltage limit warning When the system voltage peeks over 17 5 DCV or...

Page 2: ... shown in the picture to the right Notice the small mounting screw hole in the capacitor chassis CHARGING THE CAPACITOR AND WIRING The capacitor must be charged before connecting the Power and Ground cables to the capacitor Failure to charge the capacitor will result in a large spark generated from the rapid inflow of current 2 ...

Page 3: ...pacitor and the battery s positive terminal Do this for 2 3 minutes or until the charging bulb goes out Caution The charging bulb will get hot 4 Immediately take out the charging bulb from the connecting wire after the charging process And connect the positive cable of the battery directly to the positive terminal on the capacitor DISCHARGING THE CAPACITOR When you want to take out the capacitor a...

Page 4: ...or three minutes if using a resistor Multiple Capacitor Wiring Diagram ٻ LIMITED WARRANTY One Year Warranty from the date of purchase WARNING THIS POWER CAPACITOR MAY EXPLODE AND CAUSE SERIOUS INJURY IF ABUSED OR CONNECTED IMPROPERLY PLEASE REFER TO THE INSTRUCTIONS CONTAINED IN THIS MANUAL FOR CORRECT OUNTING CHARGING DISCHARGING AND WIRING CONNECTION FOR THIS CAPAPCITOR PRIOR TO INSTALLATION 4 ...

Reviews: