8
7
Remedying Malfunctions
Symptom
Possible cause
Remedy
– Change the inclination angle of the radar module
– Install sensor higher and if possible directly above the door hinge
– Increase CTM level
– Swivel the sensor in the direction of the door opening
– Activate the interference suppression filter
– Activate the special filter function MTO
(Mass Traffic Optimisation)
– Decrease the CTM level (switch off)
– Check field size
– Activate high mounting height
Refer to chapter
6.1.1
5.2.3
6.1.1
5.2.3
5.2.3
5.2.3
5.2.3
Door reverses
Door reverses
Door opens inadvertently
Door does not open –
sporadic non-detection
of an individual
Late detection or
non-detection of persons
– Sensor sees door
– Sensor sees swing door
– Interference source affects microwave field
(e.g. fluorescent tubes)
– Large group of persons
approaching
– Field too small
– Installation too high
6
Mechanical Settings of the Microwave Field
6.1.1
Tilting the microwave module
6.1.2
Swivelling the microwave module
8
Technical Data
Te
c
hnology
Transmitting frequen
c
y
Transmitting power
Operating voltage
Operating
c
urrent
Mains frequen
c
y
Temperature range
Air humidity
Mounting height
Relay output
Swit
c
hing voltage
Microwave motion detector with
planar module technology
24.125 GHz
< 20 dBm
12–36 V DC / 12–28 V AC
approx. 50 mA at 24 V DC, 24° C
50 Hz
–20° C to + 60° C
0 to 90 % rel., without condensation
up to 4 m
Potential-free changeover contact
max. 48 V ACDC
Swit
c
hing
c
urrent
Swit
c
hing
c
apa
c
ity
Housing
Weight
Prote
c
tion
c
lass
Min. dete
c
tion
speed
Cable length
Overview of
c
ountries
max. 0.5 A AC / 1 A DC
max. 60 VA / 30 W
Cover: PC; floor plate: ABS
Dimensions (W x H x D):
176 x 62 x 52 mm
150 g (without cable)
Suitable for use acc. to IP 54
5 cm/s (in sensor axis)
< 5 cm/s with SMD+ (inclination angle 35°)
5 m
EU; EFTA; US; CA
5°
45°
–30°
+30°
5°
45°
–30°
+30°
+ +
F
6
1
+
B
4
D
+ +
F
4
1
9
11
FCC approval
12
Contact
EU Declaration of Conformity
10
WEEE
BBC Bircher Smart Access,
BBC Bircher AG, Wiesengasse 20, CH-8222 Beringen, www.bircher.com
Designed in Switzerland / Made in EU
Devices with this symbol must be treated separately during disposal. This must be done in accordance with the laws of the respective countries for
environmentally sound disposal, processing and recycling of electrical and electronic equipment.
This device meets the requirements of Part 15 of the FCC regulations and the RSS-210 standard of Industry Canada.
Warning:
Changes or modifications made to this device may void the FCC authorisation to operate this device.
See attachment