10. Now that the air box has been reinstalled, connect Bazzaz injector connectors in line with the factory
harness connector and the connector located on the left side of the air box (photos 14 & 15).
11. Remove the factory shift rod from the motorcycles shift linkage. Install the supplied shift switch onto
the heim joint connected to the shift shaft of the engine. Next install the supplied replacement shift rod
between the switch and rear heim joint connected to the rear set. Note: Bazzaz shift rods are manufac-
tured to fit multiple applications and can be cut at 10mm intervals on either end to shorten for proper
positioning (photos 16 & 17).
12. Reinstall the components removed in step one of these instructions.
The Bazzaz controller is capable of storing two maps. These maps can be selected through the use of a
map select switch which can be mounted on the handlebar for easy access and can be purchased seper-
ately. Or these maps can be selected by connecting or disconnecting the map select jumper supplied with
the kit. When the map selet jumper is connected the control unit is operating using map 1. When the
map select jumper is disconnected the contol unit is operating using map 2.
Factory Injector Connector
Bazzaz Connectors
Stock
Bazzaz Shift Switch Installed
Map 1
Map 2
Photo 14
Photo 15
Photo 16
Photo 17
Factory Connector
