Page
4
ABOUT THIS DS74 OWNER’S MANUAL
COMPLIANCE
STANDARD
This document is applicable to the
DS74 (4) EIA 232 Serial Port Module
. This document provides
information required for installing and operating your Bay Tech equipment. It should allow the user to
connect to, power up, and access an applications menu where peripheral equipment can be controlled.
We recommend reading this manual carefully, while placing special emphasis on correct cabling and
configuration. If you have any problems with your installation, please contact a BayTech Applications
Engineer at
228-563-7334
, or toll free from anywhere in the United States using
1-800-523-2702
or
contact us at our Web Site,
www.baytech.net
.
BayTech manufactures many remote site management power products and data switches. If you would
like information on any of these products, please contact BayTech Customer Service at the above
numbers or visit our web site.
Conventions used in this manual include:
CAUTION:
This term is used to denote any condition that could possibly result in physical
harm to personnel or damage to equipment.
IMPORTANT:
This term is used to denote conditions that could result in the loss of
communications or to highlight the proper functioning of equipment.
NOTE:
This term is used to denote items of interest to the user.
<cr>:
Carriage Return or ENTER
The information in this document is subject to change without notice. The statements, configurations,
technical data, and recommendations in this document are believed to be accurate and reliable, but are
presented without express or implied warranty. Users must take full responsibility for their
applications of any products specified in this document. The information in this document is
proprietary to Bay Technical Associates, Inc.
In the interest of improving internal design, operational function, and/or reliability, Bay Technical
Associates, Inc reserves the right to make changes to the products described in this document without
notice.
Bay Technical Associates, Inc does not assume any liability that may occur due to the use or
application of the product(s) or circuit layout(s) described herein.
BayTech units are in accordance with the general requirements of
Standard for Information
Technology Equipment
(ETL listed, conforms to ANSI/UL 60950-1 2
nd
Edition and CAN/CSA C22.2
No. 60950-00. CE conforms to IEC 60950.)
Equipment installations are to be in accordance with the
Canadian Electrical Code, Part I, CSA C22.1-02; General Requirements – Canadian Electrical, Part
II, CSA C22.2 No 0-M91; the National Electrical Code, NFPA 70-2005; and the National Electrical
Safety Code, NFPA, IEEE C2-2002.
