Bayside Furnishings Metrex CORC-7 Manual Download Page 4

Page: 4 / 8

Model # CORC-7

Bayside Furnishings

Page 4

Factory No. 16187

Assembly Instructions

4. Place the Seat (B) upside down onto the carton with the threaded holes facing up. Align and

attach the Mechanism (C) to the Seat (B) using four 3/4” Bolts (1). As shown below. Tighten
the bolts with the enclosed Allen Wrench.

NOTE

: Place a protective cover (like the bubble wrap packing material) over the carton to

prevent from scratching the chair material.

FRONT

Ø5/16” x 3/4” Bolt

(4 used in this step)

①

Summary of Contents for Metrex CORC-7

Page 2: ...tructions and verify that all listed parts and hardware are present before beginning assembly A Back Assembly 1 B Seat 1 C Mechanism 1 D Gas Lift w Telescoping Cover 1 E 5 Star Base 1 F Caster 5 1 Ø5 16 x 3 4 Bolt 2 Ø5 16 x 1 3 4 Bolt Qty 4 1 extra Qty 4 1 extra 3 Allen Wrench Qty 1 Tools required Allen Wrench provided ...

Page 3: ...he hardware and required parts 2 To begin assembly place 5 Star Base E upside down and press the Casters F into the holes at the end of each leg 3 Turn the Star Base E upright and insert the thick end of the Gas Lift D into the center hole of Star Base Make sure the Telescoping Cover is over the Gas Lift D and rests on the Base ...

Page 4: ...hreaded holes facing up Align and attach the Mechanism C to the Seat B using four 3 4 Bolts 1 As shown below Tighten the bolts with the enclosed Allen Wrench NOTE Place a protective cover like the bubble wrap packing material over the carton to prevent from scratching the chair material 1 1 C FRONT B Ø5 16 x 3 4 Bolt 4 used in this step ...

Page 5: ...operly Insert four 1 3 4 Bolts 2 through the mounting holes on the Mechanism C and securely screw into the threaded holes on the Back Assembly A using the enclosed Allen Wrench 6 Turn the assembled seat upright and locate the centre hole of Mechanism C over the Gas Lift D Press down firmly until the seat locks in place Ø5 16 x 1 3 4 Bolt 4 used in this step ...