Bayside Furnishings Metrex CORC-7 Manual Download Page 2

Page: 2 / 8

Model # CORC-7

Bayside Furnishings

Page 2

Factory No. 16187

Parts and Hardware List

Please read completely through the instructions and verify that all listed parts and hardware
are present before beginning assembly.

A – Back Assembly (1)

B – Seat (1)

C – Mechanism (1)

D – Gas Lift w/Telescoping Cover (1)

E – 5 Star Base (1)

F – Caster (5)

(1) Ø5/16” x 3/4” Bolt

(2) Ø5/16” x 1-3/4” Bolt

(Qty. 4+1 extra) (Qty. 4+1 extra)

(3) Allen Wrench (Qty. 1)

Tools required: Allen Wrench (provided).

Summary of Contents for Metrex CORC-7

Page 2: ...tructions and verify that all listed parts and hardware are present before beginning assembly A Back Assembly 1 B Seat 1 C Mechanism 1 D Gas Lift w Telescoping Cover 1 E 5 Star Base 1 F Caster 5 1 Ø5 16 x 3 4 Bolt 2 Ø5 16 x 1 3 4 Bolt Qty 4 1 extra Qty 4 1 extra 3 Allen Wrench Qty 1 Tools required Allen Wrench provided ...

Page 3: ...he hardware and required parts 2 To begin assembly place 5 Star Base E upside down and press the Casters F into the holes at the end of each leg 3 Turn the Star Base E upright and insert the thick end of the Gas Lift D into the center hole of Star Base Make sure the Telescoping Cover is over the Gas Lift D and rests on the Base ...

Page 4: ...hreaded holes facing up Align and attach the Mechanism C to the Seat B using four 3 4 Bolts 1 As shown below Tighten the bolts with the enclosed Allen Wrench NOTE Place a protective cover like the bubble wrap packing material over the carton to prevent from scratching the chair material 1 1 C FRONT B Ø5 16 x 3 4 Bolt 4 used in this step ...

Page 5: ...operly Insert four 1 3 4 Bolts 2 through the mounting holes on the Mechanism C and securely screw into the threaded holes on the Back Assembly A using the enclosed Allen Wrench 6 Turn the assembled seat upright and locate the centre hole of Mechanism C over the Gas Lift D Press down firmly until the seat locks in place Ø5 16 x 1 3 4 Bolt 4 used in this step ...