8
These features and specifications for the LP Cylinder MUST be present. If you exchange the LP cylinder, make sure
the new tank also complies with all the specifications listed here:
45.72cm/
18-in Tall
31.75cm/12.5-in Diameter
LP Cylinder Valve
(Trilobular Handwheel
indicates OPD is present)
Type-1
Outlet
Protective
Collar
Safety
Relief
Valve
Protective
Cap
Place dust cap on cylinder valve outlet whenever
the cylinder is not in use. Only install the type
of dust cap on the cylinder valve outlet that is
provided with the cylinder valve. Other types of
caps or plugs may result in leakage of propane.
CAUTION
9.1 Kg/20 lbs capacity;
31.75cm/12.5-in diameter x 45.72cm/18-in tall
Type-1 gas cylinder valve outlet to accommodate
the hose and regulator supplied with this
appliance. The Type-1 valve must prevent gas
flow until a positive seal is obtained.
Over-Filling Protection Device (OPD) - indicated
by a trilobular handwheel.
Collar to protect the cylinder valve. Required of
any cylinder whose capacity is in excess of
1 Kg/2.2 lbs.
Safety Relief Valve
Protective cap
Cylinder must be arranged for vapor withdrawal
(not shown)
.
To Connect the Hose Valve Regulator to the LP Cylinder:
• Before attaching the Type-1 Connector to the tank, ensure the LP
Cylinder Valve is fully turned off (closed).
• Confirm the Control Knob on the HVR is turned off (closed) as well.
• Place the LP cylinder upright, and locate it at least 50.8cm/20-in from
the appliance. (See
Placement of Cooker)
• Remove the Protective Cap from the Type-1 Outlet.
• Screw the ACME Type-1 Connector on the HVR to the Type-1 Outlet
on the LP Cylinder by hand and tighten to a full stop. Do not use tools.
To Disconnect the Regulator from the LP Cylinder:
• Before disconnecting the regulator from the tank, ensure the LP
Cylinder Valve is fully turned off (closed).
• Confirm the Control Knob is turned off (closed) as well.
• Disconnect the Type-1 Connector on the regulator from the Type-1
Outlet on the LP Cylinder.
• Replace the Protective Cap over the Type-1 Outlet.
Upright
Position
Hand
tighten
only
Replace
Dust Cap
