Bayliner 255 Cruiser, Owner'S Manual

Page: 57 / 92

255 Cruiser • Owner’s Manual Supplement Chapter 6: Plumbing
51
Marine Head & Black Water Holding Tank
Manual Flush Head (If Equipped)
•
Before using this sys-
tem, read the marine
head’s operation and
maintenance manual.
•
Look at the side of the
black water holding tank
to check the content
level.
•
The dockside pump-out
deck fitting is marked
WASTE.
•
Empty the black water
holding tank at every
opportunity.
Using the Marine Head
1. Open the head’s seawa-
ter intake seacock (the
location of this sea-
cock is described in the
Component Locations
section of Chapter 2 ).
2. Before using the head,
pump water into the
bowl to wet the sides.
3. After use, pump until the bowl is clean.
4. Pump a few more times to clean the lines.
5. If excess waste causes the water to rise in the bowl, stop pumping until the water recedes.
•
Close the intake seacock when the system will not be used for long periods of time.
Winterizing the System
Read the marine head’s operation and maintenance manual for winterizing instructions.
Check with local authorities about the legal use of marine head systems.
NOTICE
FLOODING and SWAMPING HAZARD!
•
Close the seawater intake seacock when leaving your boat unattended for any length
of time.
•
If the seacock is left open, a hose failure could flood the bilge, swamp the batteries and the
engine, and even sink your boat.
WARNING!
!