13
Digital Audio Baby Monitor
EN
–
In the event that the batteries are almost fl at, a sound alert will be made approximately every
30 seconds while the display will light up for a short time. Symbol D
5
and "LOW BATT" (almost
fl at batteries) will fl ash on the display C
3
. These elements will inform you that the parent unit A
1
needs to be connected to an external power source in order for the batteries to recharge. If you do
not connect the parent unit A
1
to an external power source, it will turn itself off automatically after
a certain time. The On LED indicator C
1
and the LCD display C
3
will turn off.
Note:
The interval after which the parent unit A
1
automatically turns off depends on the mode in which the
parent unit A
1
is, the battery capacity, battery age, etc.
–
In the event that you are planning not to use the baby monitor for an extended period of time, take the
batteries out of the parent unit A
1
and store them out of the reach of children.
Using the baby monitor
1. Baby
unit
■
Turning on and off
–
The baby unit A
2
will turn on automatically when it is connected to a working power socket. This is
signalled by the LED indicator B
1
being lit.
–
To turn off the baby unit A
2
, press the On/Off button B
2
and hold it down for approximately
2 seconds. The turned off state of the baby unit A
2
is signalled by the LED indicator B
1
turning off.
–
To turn the baby unit A
2
that is connected to a power socket on again, it is necessary to press the
On/Off button B
2
and hold it down for approximately 2 seconds.
–
When you have fi nished using it, always turn off the baby unit A
2
and disconnect the power adapter
A
3
from the power socket.
2. Parent
unit
■
Turning on and off
–
The parent unit A
1
automatically turns on when it is connected to a working power socket or after the
batteries are inserted, unless they are completely fl at. When the parent unit A
1
is turned on, all the
segments on the display C
3
will be shown for a short time. Then symbol D
2
will start fl ashing on the
display C
3
and the message "NOT LINKED" (no connection) will appear and the Connection/On LED
indicator C
1
will start fl ashing. These elements signal that no connection has been made. In the event
that the baby unit A
2
is turned on and located within signal range, the connection will soon be made
automatically. This is signalled by the message "NOT LINKED" turning off and the LED indicator C
1
and symbol D
2
on the display C
3
being lit permanently. Instead of the message "NOT LINKED", the
air temperature measured by the baby unit A
2
in the room where it is located will be shown.
Summary of Contents for BBM 7010
Page 2: ...EN 3 CZ 23 SK 43 HU 63 ...
