15
Note:
- Many card swipe systems have a voltage threshold that
can be adjusted in the card swipe menu. Please set this
“Game Drive Threshold” to 2 Volts.
Option #2:
If your card swipe systems does not have a standard 9 pin
Molex connector, then you will have to splice wires into the
AACE23011 harness.
Black wire is ground. (common)
Green wire is coin signal.
Yellow wire is +12 Volts DC
CARD SWIPE SYSTEM INSTALLATION
The Hypernova game is pre-wired with a UCL (Universal Card Link) connector to accept Card Swipe
systems from many different manufactures.
Please follow these instructions to make full use of this capability.
Menu Changes
Enter menu, scroll to “Credit” Menu
Verify “Credits” set to 1
Scroll to “Card Swipe” Menu
Verify set to “1”
Check dipswitches on the I/O Aux Board in the front of game. Verify Dipswitch # 5 ON
Option #1:
Card swipe systems may come with a standard 9 pin Molex
connector. This is the UCL connector.
Simply plug this connector into your
card swipe reader.
This would
normally plug
into coin
mechanism.
AACE23011
AACE23011
AACE23011
AACE23011
This would
normally plug
into coin
mechanism.
