23
Tickets do not
dispense.
Swap cable
from one out-
put on main
board to the
other to verify
cable/
dispenser
problem or
main board
problem.
Ticket tray empty due to faulty
low ticket switch or broken/
loose wires. Switch stuck or
switch wire bent out of position.
Faulty cable to dispenser.
Dirty opto-sensor or paper
dust buildup in ticket dispenser
Notch on tickets too shallow.
Ticket dispenser faulty.
Main circuit board malfunction.
Fill ticket tray. Replace low ticket switch(AASW200).
Repair wiring. Clean ticket tray of dirt, loose tickets or
debris. Bend switch wire to correct position under
tickets.
Check wiring continuity from dispenser to main board
(AACE4606, AACE4605, AACE4600) Check for
pinched, broken or disconnected wires.
Replace as necessary.
Clean with compressed air and if necessary wipe
sensor with isopropyl alcohol on a cotton swab.
Flip tickets and load upside-down to have large cut
notch toward opto sensor.
Replace dispenser with spare working dispenser
(A5TD1)
Replace main board if possible to isolate the problem
to the main circuit board. (AANEWGEN1-PJ)
Wrong
number
of tickets
dispensed.
Ticket Pattern set wrong.
Dirty opto-sensor on ticket dis-
penser.
Many tickets in memory. If ticket
meter is counting the tickets
coming out, then reset game.
Notch on tickets cut too shallow.
Faulty ticket dispenser.
Main circuit board malfunction.
Enter menu and cycle to Game Menu.
Verify correct settings for Ticket Patterns, Jackpot
Value, and Double Ticket Value
Clean with compressed air or wipe with isopropyl
alcohol on a cotton swab.
Turn game off, wait 10 seconds, and turn game back
on.
Flip tickets and load upside-down to have large cut
notch toward opto sensor.
Replace with spare working dispenser (A5TD1).
Swap cable from one output on main board to the
other to verify cable/dispenser problem or faulty main
board. (AANEWGEN1-PJ)
Menu buttons
do not work.
Stuck pushbutton.
Cable problem.
Faulty pushbutton.
Inspect pushbutton to make sure it is not stuck.
Check continuity on connector.
Check cable from pushbutton to main board.
(AAPB2700 & AACE4608)
Replace pushbutton. (AAPB2700)
Symptom
Probable Cause
Remedy
TROUBLESHOOTING GUIDE
