Point-to-Point Protocol (PPP)
4-4
893-826-A
•
DEFINE PORT port-list PPP CHARMAP [nnnnnnnn]
SET PORT port-list PPP CHARMAP [nnnnnnnn]
These commands specify the ASCII control characters that the port can
negotiate to control how data is transferred between the two sides of the
PPP connection.
•
DEFINE PORT port-list PPP KEEPALIVE TIMER time
SET PORT port-list PPP KEEPALIVE TIMER time
These commands specify the frequency at which the specified port(s) will
send a Link Control Protocol (LCP) echo request packet over the PPP link
to the connection partner. Valid values for time are 0 through 255
(seconds). The default is 0, which means that the PPP link will not send
LCP echo request packets.
•
DEFINE PORT port-list PPP KEEPALIVE TIMEOUT time
SET PORT port-list PPP KEEPALIVE TIMEOUT time
These commands specify the amount of time that the specified port(s)
should wait to receive a Link Control Protocol (LCP) echo reply packet
from the connection partner before terminating the PPP link. Valid values
for time are 0 through 65535 (seconds). The default is 0, which means that
the PPP link will not look for LCP echo reply packets. The presence of
other PPP traffic does not affect this time-out period (i.e., if the connection
partner does not send an LCP echo reply packet, the link will be
terminated even if other traffic has been sent).
•
DEFINE PORT port-list PPP PACKET LOGGING setting
SET PORT port-list PPP PACKET LOGGING setting
These commands specify whether or not PPP negotiation packets will be
logged in the verbose accounting log and the format in which they will be
logged. Valid values for setting include NONE, INTERPRETED, or RAW.
The default is NONE. This should be used as a diagnostic tool only in the
event of interoperability problems.
Configuring IPCP Connections
After the port has been configured for PPP operation, you must configure IPCP.
This procedure requires four tasks:
•
Assign local and/or remote IP addresses.
•
Specify optional IPCP PORT characteristics.
•
Configure static IP routes (optional).
•
Configure a unit to use IP filtering features, covered later in this chapter
(optional).
This section also depicts example IPCP single-node and network
configurations.
Summary of Contents for 3395A
