baxter Colleague 3 CXE, Operator'S Manual

Page: 146 / 230

7
Maintenance
7-2
COLLEAGUE CXE VOLUMETRIC INFUSION PUMP OPERATOR’S MANUAL 071960491
When cleaning, take care to ensure the following:
„
Do not submerse the pump in liquid or allow the pump to sit in a
puddle of liquid.
„
Do not spray solutions directly onto nor into the pump.
„
Do not saturate the pump.
„
Do not use cotton swabs to clean the tubing channel as it is
possible for the swabs to leave lint.
Clean the exterior of the pump after each use. Holding the pump upright,
clean all surfaces using a premade wipe or a sparingly dampened soft
cloth. If the cloth has been saturated, it must be wrung out prior to
contact with the pump. A foam tipped sponge (Baxter part number
TWTX740B) can be used to clean contaminants from corners, recessed
areas, the channel slot, the slide clamp prism, the Manual Tube Release
area, and seams.
Use any of the approved cleaning solutions listed below:
„
70.0% Isopropanol (IPA alcohol).
„
2 - 7% Sodium hypochlorite (bleach) diluted with 90% water to
create a 10% bleach solution.
„
3.0% Hydrogen peroxide. Final concentration is 3%
„
1.7 g Sodium dichloroisocyanurate tablets. Use blood
concentration or 10 tablets per liter of water = 10,000 PPM
chlorine.
„
Isopropanol 17.2%; Disobutylphenoxyethyl dimethyl benzyl
ammonium chloride 0.28%. No further dilution.
„
Isopropanol 55.0%, Alkyl*dimethyl benzyl ammonium chloride
0.25%, Alkyl*dimethyl ethylbenzyl ammonium chloride 0.25%.
Allow the pump to dry completely after cleaning before bagging.
Maintenance
Preventive Maintenance
The table below contains a schedule of basic maintenance tasks that
should be performed on the pump. If the pump cannot be cleaned using
the basic methods described earlier or components are missing or
damaged, discontinue use and notify the appropriate Baxter-trained,
qualified personnel. To contact Baxter for service or repair, see “Service
Information,” 10-2.
For information on calibration, see the COLLEAGUE Pump Global
Service Manual .