Fitting the Lamp, Fuel support and pebbles.
1.
The rear panel of the heater may be
covered in protective film. Carefully remove
this before continuing.
2.
Locate the lamp into the lamp holder (See
point 1 in figure 3).
3.
Place the fuel support into the top of the
bowl (See point 2 of figure 3).
4.
Place the pebbles on top of the fuel support.
It is not necessary to use all the pebbles
supplied.
Important notes.
The pebbles are for decorative purposes
only. There is a choke risk to young
children. Make sure they cannot gain
access to them.
5. USING THE HEATER
Important Safety
Never cover the heater or obstruct the openings at the top of the heater, this
could cause overheating and consequent risk of fire.
What are the three switches for?
The heater and effect are operated by three switches located on the underside of the
top shelf of the heater.
Switch 1 =
Main On - Off. (In the ‘ON’ position, only the flame
effect operates)
Switch 2 =
1kW fan heat setting and flame effect. (Switch 1 needs
to be in the ‘ON’ position to enable switch 2 to operate).
Switch 3 =
2kW fan heat setting and flame effect. (Switches 1 & 2
need to be in the ‘ON’ position to enable switch 3 to
operate).
Page 8
© Baxi Heating U.K. Limited 2009.
INSTALLER AND OWNER GUIDE
Figure 3.
