Page 8
CLEANING YOUR FIRE
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the guard
and trims using soapy water.
Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see below for how to remove the
radiants.
REPLACING THE RADIANTS
(See figure 4).
Always use the correct type of replacement radiant. Ask for part number 5110472.
Turn the fire off and allow it to cool before attempting to remove the radiants
.
!
Remove the dress guard by pressing down the two hooks at the top. Tilt the guard
forward and lift out.
!
Lift the radiant upward to clear the metal retaining bar then pull out bottom first.
!
Fit the new radiant by inserting its top under the top lip of the radiant box then
swing the bottom of the radiant over and behind the retaining bar.
It is important that
that the rear face of the radiants rest against the horizontal ribs in the rear panel.
There will be a small gap between their bottom front edges and the retaining
OWNER GUIDE
Figure 4. Replacing radiant(s)
