ANNUAL SERVICE
THIS GAS APPLIANCE MUST BE SERVICED
EVERY TWELVE MONTHS BY A QUALIFIED
GAS ENGINEER.
See "SAFETY NOTICES" ref coal set
Step 1
Isolate the gas supply to the fire using
the gas cock supplied at installation.
Step 2
With the appliance cold, open the main
door by turning the handle through
180° degrees.
Step 3
Carefully remove and clean the fuel effect
coals of any soot deposits with a soft
brush.
Step 4
Inspect chimney. Please note periodic
chimney sweeping is vital gas fire
maintenance.
Step 5
Remove any soot deposits from inside
the fire using a vacuum cleaner.
(See note under ‘Coal set’ on page 4)
Step 6
Inspect the pilot assembly to ensure
that it is clean, unobstructed and in
good order.
Step 7
Check system for gas soundness.
Step 8
Replace the coal set as described in
"arranging the coals".
CLEANING OUTER SURFACES
To clean the outside first the appliance must be
cold.
The outside finish of the fire is a durable high
temperature paint. It is best cleaned by using a soft
brush. Do not allow moisture to remain on the fire
whilst cold or surface rust may occur.
CLEANING DOOR GLASS
To clean the door glass the appliance must be cold.
Open the main door by turning the handle through
180° degrees. When cleaning the inside of the door
glass care should be taken that no damage is caused
to the door sealing gasket.
20
Baxi Gas Stoves
SERVICING
