2.0 Introduction
4
2.1
Introduction
1. Your Baxi Bermuda Inset 3 Super is a central
heating boiler combined with a gas fire. The
firefront is of the Decorative Fuel Effect type and
incorporates an optional illumination effect for
use when the fire is off. The boiler will provide
heating for the rest of the house and also
domestic hot water if required. The boiler and fire
are independently controlled.
2. The boiler may be controlled by an external
programmer or clock control (see separate
instructions with the clock controller used).
Manual control is available with the boiler
thermostat control.
NOTE:
The fire or illumination effect will not
function in the event of a power failure.
2.2
Controls and Identification
(Fig. 1)
1. The controls for the fire are situated on the
upper left hand side of the fire surround.
2. Remove the controls access door at the
bottom of the fire to gain access to the boiler
controls.
3. Fire identification is situated on the inner right
hand side panel behind the controls access door.
4. Boiler identification is on the boiler controls
behind the controls access door.
5. Before operating the unit ensure that the main
gas and electricity supplies are turned on.
2.3
Pilot/A.S.D.
1. Both the boiler and firefront are fitted with a
pilot light that also acts as an Atmospheric
Sensing Device. This means that in the event of
the flow of gases out of the flue being interrupted
the pilots will extinguish and shut the fire and
boiler down. If this occurs persistently your
installer or British Gas Service should be
contacted immediately.
Controls Access Door
Controls Access Door
Controls & Bezel
Bermuda Inset 3
TS, BS, KS & SC Super
Bermuda Inset 3
FS, BB, CB & BC Super
Boiler Thermostat
Knob
Boiler Thermostat
Knob
Fig. 1
ON/OFF
Button
HIGH/LOW
Button
Illumination
Button
Green
Illumination
ON Indicator
Green Power
ON Indicator
Green
High Setting
Indicator
Summary of Contents for Bermuda Inset 3 Super
Page 10: ...8 0 Notes 10 ...