8. PREPARING APPLIANCE FOR INSTALLATION
1.
Detach the burner unit from the
convection box by removing two screws
(See figure 9). Lift the burner unit clear.
2.
Fit the two “U” section seals to the
bottom edges of the convection box side
flanges (See figure 10).
3.
It is important that the grommet
supplied in the loose parts pack is
fitted to the hole in the rear of the
convection box.
4.
For concealed connection only:
Pierce the grommet to allow the pipe to pass through it.
The grommet should envelop the pipe. If the hole is larger
than the pipe, seal it with tape.
Do not pierce the
grommet unless the supply pipe is to pass through it
.
5
. The heat engine or fascia will have a canopy shield
supplied with it. Fit this to the convected air outlet of the
appliance using the three self tapping screws supplied.
The design of the canopy shield may differ from that
shown (See figure 11).
Page 20
©
Baxi Heating U.K. Limited 2010.
Figure 11. Fitting canopy shield
Figure 10. ‘U’ Seals
Figure 9. Burner attachment points
INSTALLER GUIDE
