6.3
Installation of the burner unit
6.3.1
Prior to installation of the burner the
rear ceramic support bracket must be fitted
(See figure 7). Secure with two self-tapping
screws but do not over-tighten as these will
have to be removed again when installing
the burner.
6.3.2
Burner Tray trim.
The trim is
not
to be fitted to
Anthem or Quattro models.
The fire is supplied with a
burner tray trim. Fit the trim as in
figure 8.
6.3.3
Burner Positioning.
The two tags at the side of the burner can be
folded against the side of the burner tray. This may be
required for installations where the width of the
fireplace opening is restricted or when fitting into a
‘Spanish Basket’ casting (See figure 9).
Page 19
© Baxi Heating U.K. Limited 2009.
Figure 9. Burner tags
Figure 8. Burner tray trim
Figure 7. Fitting the rear support plate
INSTALLER GUIDE
