due to the indeterminate life span and
ease of replacement, they are specifically
excluded from the guarantee.
To replace the light bulb(s).
1.
To gain access to the light bulb/s,
remove the loose coals / pebbles from the
fuel support and place them onto an old
newspaper or plastic bag. This will
prevent them from marking the surface.
2.
Remove the firefront, On the Twilight
model it will be necessary to remove the
whole fascia. Remove the fascia in the
reverse order to that shown in the ‘Fitting
the fascia’ section of this guide.
3.
Remove the black cover plate. To do this remove the two screws from the front of the
cover plate.
4.
Remove the copper reflector plate.
5.
Replace the light bulb/s with clear 40 Watt (maximum) candle, Edison screw, SES
E14.
6.
Refit the copper reflector plate. Refit the cover plate / fascia / firefront and coals /
pebbles.
2. My heater is on but there is no light or heat.
The first thing to do is check the wall socket. To do this plug in a known working
appliance. If the appliance you have plugged in works then there is a good chance that
the problem lies with the 13Amp fuse in the heater plug. If either fuse or socket is
suspected, have them checked by an electrician.
3. My heater is on but there is no heat.
A cut out device is fitted to the heater to prevent damage due to over heating. If it
operates due to an obstruction in the airflow, the heater must be turned off and allowed
to cool for 15 minutes and the obstruction removed before restarting.
Page 16
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 20. Bulb replacement
