will keep the trims together. Locate the trims to the heater as in figure 11.
6.
On
Blenheim, Homeflame Traditional
and
Sonnet
heaters locate the lower firefront
casting onto the product. The two screws on the rear of the firefront casting locate into
the two keyhole slots in the product.
On
Debut
and
Flare
heaters locate the lower firefront casting onto the product. The
two screws on the rear of the firefront casting locate into the two keyhole slots in the
plastic fuel support.
7.
Place the loose coals / pebbles on top of the fuel support. It is not necessary to use all
the coals / pebbles supplied.
USING THE HEATER
Important Safety
Never cover the heater or obstruct the openings at the base of the heater, this could
cause overheating and consequent risk of fire.
What are the three switches for?
The heater is operated by three switches located below the hood on the left hand side of
the heater.
Switch 1 =
Main On - Off. (In the ‘ON’ position, only the flame
effect operates)
Switch 2 =
1kW fan heat setting and flame effect. (Switch 1 needs to
be in the ‘ON’ position to enable switch 2 to operate).
Switch 3 =
2kW fan heat setting and flame effect. (Switch 2 needs to
be in the ‘ON’ position to enable switch 3 to operate).
CLEANING AND MAINTAINING THE HEATER
How do I Clean my heater?
The heater fascia, spacer frame and plastic parts need only to be wiped clean with a dry
soft cloth, do not use polishes or abrasive materials. Heaters with fascia, other than
brass, may have finger prints on the fascia surface. These can be removed by applying a
small amount of ‘baby oil’ to a lint free non-abrasive cloth and wiping the surface. Use
a clean cloth to remove the oil.
Page 11
INSTALLER AND OWNER GUIDE