then replace as below.
The light bulbs fitted to this heater are standard clear 40W max. E14 candle lamps, but
due to the indeterminate life span and ease of replacement, they are specifically
excluded from the guarantee.
To replace the light bulb(s).
1.
To gain access to the light bulb, remove the
loose coals / pebbles from the fuel support and
place them onto an old newspaper or plastic bag.
This will prevent them from marking the surface.
2.
Remove the firefront, (On the Adage and
Fusion heaters it will be necessary to remove the
whole fascia), see figure 3 and the section headed
“ Removing the fascia”. On the Fusion model the
fuel support can be removed from the heater by
removing four screws (See figure 19).
3.
Lift out the copper reflector plate (See figure 11).
4.
Replace the light bulb with a clear 40 Watt (maximum) candle, Edison screw, SES
E14.
5.
Refit the copper reflector plate. Refit the firefront / fascia and refit the coals /
pebbles.
2. My heater is on but there is no light or heat.
The first thing to do is check the wall socket. To do this plug in a known working
appliance. If the appliance you have plugged in works then there is a good chance that
the problem lies with the 13Amp fuse in the heater plug. If either fuse or socket is
suspected, have them checked by an electrician.
3. My heater is on but there is no heat.
A cut out device is fitted to the heater to prevent damage due to over heating. If it
operates due to an obstruction in the airflow, the heater must be turned off and allowed
to cool for 15 minutes and the obstruction removed before restarting.
Page 17
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2005.
Figure 19. Removing the Fusion
fuel support.
