Remove the pressure gauge and replace the test point sealing screw.
3.
Relight the appliance. Turn to the maximum output position and test around the
sealing screw for gas soundness with a suitable leak detection fluid.
8. FITTING THE FIREFRONT
8.1
For models NOT supplied with a Firefront.
A slotted firefront with a
minimum
free area as shown in figure 12 must always be
used.
8.2 For models SUPPLIED with a firefront.
The firefront supplied with this fire has been tested and found to be satisfactory for use
with this fire. The open area may differ slightly from that shown in figure 12.
Place the decorative
firefront on the
hearth and central to
the appliance.
‘Quattro’ /
‘Anthem’ firefront
only
1.
The Quattro /
Anthem firefront is
fitted with a set of
fixing brackets. Each
bracket has two
threaded holes. As
supplied the top threaded hole
should be fitted with a 25mm long
machine screw. Remove the
machine screw and locate to the
threaded hole below.
2.
The screw should be set at a
distance of 7mm (Measured from
the surface of the bracket to the
underside of the screw head).
Adjust the screw to this distance
(See figure 13).
Page 18
INSTALLER GUIDE
Figure 13. Bracket locations
Figure 12. Firefront minimum open area requirements
