bautek Fluggeräte Kite, Operating Instructions Manual

Page: 4 / 17

-3-
Push the rear sections of the leading edge tubes from the rear into the sail. Let the
swivel tip exit the double sail at the zipper opening and push the tube into the front
leading edge tube with the swivel tip cable pointing up. The swivel tip will swing to the
rear. Press both snaps in and see that both snap out again through the holes in the
front tube.
Then pull the wide, black, inside loop at the end of the sail leading edge over the end-
cap of the rear leading-edge tube. There is an auxiliary loop, which helps to do this.
Pay attention to the proper seating of the loop webbing in the grove of the plastic end-
cap. Close the Velcro loop inside the sail to keep the black loop from moving out of its
grove during transport.
Spreading the sail and inserting the upper battens
Stand the glider on the control bar and raise the kingpost.