DinBox PSTN Reference manual – V1.3
Bausch Datacom NV
18
8.
AT Command interface
8.1
Standard command overview
The configuration of the
DinBox PSTN(485)
is done by sending AT command to the
modem, changing S-registers into the modem and interpreting the responses sent by
the modem.
We have added the original Conexant reference manual onto the CD-ROM.
Below you will find a overview of all the possible command and S-registers.
Data Commands
3-2
Generic Modem Control
3-2
Z - Soft Reset and Restore Profile
3-2
+FCLASS - Select Active Service Class
3-2
+VCID - Caller ID (CID)
3-3
+VRID - Report Retrieved Caller ID (CID)
3-4
\N - Operating Mode
3-5
I - Identification
3-6
+GMI - Request Manufacturer Identification
3-7
+GMI9 - Request Conexant Identification
3-7
+GMM - Request Model Identification
3-8
+GMR - Request Revision Identification
3-8
+GCAP - Request Complete Capabilities List
3-8
+GCI - Country of Installation
3-9
&F - Restore Factory Configuration (Profile)
3-10
&T - Local Analog Loopback Test
3-10
&Y - Designate a Default Reset Profile
3-11
&W - Store Current Configuration
3-11
&Zn=x - Store Telephone Number
3-12
%7 - Plug and Play Serial Number
3-12
%8 - Plug and Play Vendor ID and Product Number
3-13
**- Load Flash Memory
3-14
DTE-Modem Interface commands
3-17
E - Command Echo
3-17
Q - Quiet Results Codes Control
3-17
V - Result Code Form
3-18
W - Connect Message Control
3-18
X - Extended Result Codes
3-19
&C - RLSD (DCD) Option
3-24
&D - DTR Option
3-24
&K - Flow Control
3-25
&M - Asynchronous/Synchronous Mode Selection
3-26
&Q - Sync/Async Mode
3-27
&R - RTS/CTS Option
3-28
&S - DSR Override
3-28
&X - Select Synchronous Clock Source
3-29
+IPR - Fixed DTE Rate
3-30
+IFC - DTE-Modem Local Flow Control
3-31
+ILRR - DTE-Modem Local Rate Reporting
3-32
+IBC – In Band Commands
3-34
Call Control
3-37
D - Dial
3-37
T - Set Tone Dial Default
3-40
P - Set Pulse Dial Default
3-40
A - Answer
3-40
