TAM 00695
5
DST2-135
– 400 W
10 / 2019
Three-phase synchronous motor, water-cooled
English
1.2
Designated use
The electric motor must only be used for its designated purpose. In this context, the electric motor
must only be used for the applications described in this technical documentation under strict
observance of all the notes in these Commissioning and Maintenance Instructions.
All assembly, commissioning, maintenance and operating tasks must be carried out by
qualified
personnel
only.
Within the context of these safety instructions, qualified personnel refers to persons who are
trained and authorized in the specialized area, who are authorized to set up, assemble,
commission and operate devices, systems and circuits under application of the applicable safety
standards (in accordance with EN 50110-1).
Inappropriate action can cause serious damage to persons and property.
The
electric motor
is designed to be used for
industrial applications
and is subject to a number
of
standards
and
directives
, including the following:
Standards
EN 60034-1, EN 60034-5, EN 60034-6, EN 60034-7, EN 60034-9, EN 60034-11,
EN 60034-14, EN 60204-1
EU Low Voltage Directive
The electric motors in this series fully comply with the requirements of the Low Voltage Directive
2014/35/EU (conformity).
EU Machinery Directive
Electric motors are components which are intended to be installed in machines as described in
the Machinery Directive. Commissioning is not permitted until such time as the conformity of
the finished product with this directive has been established (refer to EN 60204-1 "Electrical
Equipment of Machines").
EU EMC Directive
The operation of the electric motor in accordance with its designated use must comply with the
safety requirements in the EMC Directive EC. The proper installation (e. g. separation of signal
lines and power cables, screened lines and cables etc.) is the responsibility of the erector of the
installation and the system provider. During converter operation the EMC information of the
converter-, encoder- and brake-manufacturer must be observed.
All national, local and system-specific regulations must also be followed!
The electric motor is designed for the following
ambient conditions:
• Ambient temperature: 0 °C to +40 °C
• Altitude:
1000 m above sea level
• Relative humidity:
5 % to 85 %
Please take note of any deviating details specified on the nameplate or in the technical
documentation. The conditions at the place of utilization must correspond to the details on the
rating plate.
Utilization in hazardous areas is
prohibited
, unless the unit is expressedly designed
for this purpose (refer to additional notes). Furthermore, the area surrounding the
electric motor must be free of inflammable gas mixtures and concentrations of dust.
Live and hot motor parts are inflammable and may cause serious injury and damage
to property.
If, in special cases, greater requirements are placed
– for utilization in non-industrial
applications
– (e.g. protection against contact with a child’s fingers), these conditions
must be by the customer met when installing the system.