TAM 00746
5
DSP1 045 - 100
11 / 2019
Three phase synchronous motor
English
1.2 Intended use
The use of the electric motor is permitted only within its intended use. In this context, the electric
motor may only be used for the applications specified in the technical documentation, observing all
instructions in these commissioning and maintenance instructions.
All work relating to installation, commissioning, maintenance and during operation may only be car-
ried out by qualified personnel.
In the sense of the safety information given here, qualified personnel means a person trained and
authorized in the field who is authorized to install, assemble, commission and operate devices, sys-
tems and circuits in accordance with the applicable safety standards (EN 50110-1).
Improper behaviour can cause serious
personal injury and damage to property
.
This
electric motor
is intended for the use in
commercial systems
and is subject to the following
standards
and
guidelines:
Standards
EN 60034-1, EN 60034-5, EN 60034-6, EN 60034-7, EN 60034-9, EN 60034-11, EN 60034-14
EN 60204-1
EU Low Voltage Directive
Electric motors of this series meet the requirements of the Low Voltage Directive (2014/35/EU (con-
formity).
EU Machinery Directive
Electric motors are components for installation in machines within the meaning of the Machinery Di-
rective. Commissioning is prohibited until the conformity of the end product with this directive has
been established (observe EN 60204-1 "Electrical equipment of machines").
EU EMC Directive
The operation of the electric motor in its intended use must meet the protection requirements of the
EMC Directive 2014/30/EU. Proper installation (e.g. spatial separation of signal lines and power ca-
bles, shielded lines and cables, etc.) is the responsibility of the installer of the system and the sys-
tem provider. In converter operation, the EMC instructions of the converter, encoder and brake
manufacturer must also be observed.
In addition, observe the binding national, local and plant-specific regulations!
The electric motor is designed for the following
ambient conditions:
Ambient temperature:
0 °C to +40 °C
Altitude:
1000 m above sea level
Relative humidity:
5 % to 85 %
Observe any deviating information on the type plate or in the technical documentation. The condi-
tions on site must comply with all specifications on the type plate.
The use in hazardous areas is
prohibited
unless expressly provided for. (Observe
additional instructions) There must also be no combustible gas mixtures or dangerous
dust concentrations in the vicinity of the electric motor. Live and hot motor parts could
inflame itself and cause serious injuries and material damage.
If in special cases - in use in non-commercial systems - increased requirements are
placed (e.g. protection against contact with children's fingers), these conditions must
be ensured by the system during installation.
