Baumuller BUG 2, Technical Description And Operations Manual

Page: 21 / 62

Assembly
BUG 3/2/20 Basic Feed Unit
13
Baumüller Nürnberg GmbH
5.96064.02
4 A
SSEMBLY
WARNING
The owner is responsible for assembly of the described unit, motor, transformer as well as any other
equipment in accordance with safety regulations, such as DIN or VDE; equally, you must ensure that
all other relevant national and local regulations are met with regard to cable ratings and protection,
grounding, disconnectors, overcurrent protection, etc.
Protect drive converters from impermissible loading. In particular, components may not be warped
and/or insulation gaps changed during transportation and handling. Avoid touching electronic compo-
nents and contacts.
Ensure that there is no blockage of cooling air flowing into and out of the equipment and that there is
enough space above and below the equipment to prevent overheating.
The units are protected from direct contact by being installed in commercially available switching cabi-
nets that meet the minimum protection requirements of preliminary standard EN 50178/VDE
0160/11.94, Section 5.2.4.
Plastic protectors on the devices that cover up the connections act as additional guards preventing
accidental contact at commissioning and in the case of casual use of control elements located close to
the equipment (DIN VDE 0106 Part 100, Accident Prevention Regulation VBG4 "Electrical Systems
and Equipment").
Drive converters contain components at risk from electrostatic energy which can be damaged by incor-
rect handling.
Electrical components must not be mechanically damaged or destroyed as this could lead to health risks!
WARNING
Lifting incorrectly can result in personal injury or damage to property. The device should only be lifted
by appropriately qualified personnel using the proper equipment.