Basic Safety Instructions
Instruction handbook
CANopen slave
BM4-O-CAN-03
Document no. 5.02014.06
15
2
2.6
Safety devices
During the transportation the plug-in modules are protected by their packing. Don't take
the plug-in module out of the transportation packing until shortly before you want to mount
it.
The dust cover of the controller of the b maXX devices protects in the class of protection
IP20 the plug-in modules from dirt and damages caused by static discharges due to
touches. So, please, after mounting the plug-in module, attach the dust cover again.
2.7
Training of the personnel
WARNING
The following
may occur
,
if you do not observe this warning information:
m
serious personnel injury
m
death
devices of the company Baumüller Nürnberg GmbH may only be assembled, installed,
operated and maintained by qualified personnel.
Qualified personnel (professionals) is defined below:
Qualified
personnel
Authorized electronic engineers and skilled persons of the customer or third persons, who
have learned the installation and commissioning of Baumüller drive systems and who are
authorized, to put circuits and devices into operation according to the standards of the
safety technology, to ground and to label.
Qualified personnel has a training or an instruction due to the local valid standards of the
safety technique in maintenance and usage of an adequate safety equipment.
Requirements to
the operating per-
sonnel
The operating of the drive system must only be executed by persons, who have had a
training, who have been instructed and who have been authorized for this.
Fault clearance, servicing, cleaning, maintenance and exchange must only be carried out
by skilled or instructed personnel. These persons must know the operating manual and
must act according to this.
The commissioning as well as the instruction must only be carried out by Qualified per-
sonnel.
Summary of Contents for b maXX BM4-O-CAN-03
Page 69: ......
