Scroll Saw - SS16
E&OE
© 2017 Baumr-AG
3
Product Use and Care
•
Use supplied or recommended
accessories only. Follow the
instructions supplied with the
accessory. The use of improper
accessories may cause risk of injury
and void any warranty.
•
Do not reach under the scroll saw
table when the motor is running.
•
Switch the machine OFF and
disconnect it from the electrical supply
before changing the blade, performing
maintenance or making adjustments.
•
Make sure the switch is OFF before
plugging in the power cord to an
electric outlet.
•
Carry the machine by its base. Do not
move it by pulling on the power cord.
•
Secure the machine to a firm and
level surface with adequate space
around it for working.
•
Before moving the machine,
disconnect the power cable from the
electrical supply.
•
Always hold the work-piece firmly
against the table.
•
Always feed the work-piece into the
machine at the rate the saw will cut.
•
Do not start the machine with the
work-piece touching the blade.
•
Use caution when cutting round or
irregularly shaped work-pieces.
Round items may roll and irregularly
shaped work pieces can pinch the
blade.
•
Obtain advice from a qualified person
if you’re not thoroughly familiar with
the operation of scroll saws.
•
Make sure the table is locked into
position before starting the machine.
•
Do not use dull or bent blades.
•
When cutting large work-pieces,
make sure the material is supported
at table height.
•
If the blade jams, switch the machine
OFF and disconnect it from the
electrical supply. Jams are usually
caused by sawdust filling the cut.
Wedge open the work-piece just
enough to back out the blade, then
clear the cut.
Electrical Information
•
Electrocution / shock hazard
- The
machine MUST be connected to a
properly grounded electrical socket.
Check with a licensed electrician or
service personnel if you do not
completely understand the grounding
instructions or whether the tool is
properly grounded.
•
Do NOT use the equipment if the
electrical supply cable or plug is
damaged
– have the equipment
repaired.
•
Extension cords MUST be grounded
3-wire types. For lengths up to 25m,
the wires must have a cross section
of 1.5mm
2
. Extension cords over 25m
long must have a minimum cross
section of 2.5mm
2
.
•
Before connecting the machine to the
electrical supply, ensure the electrical
supply conforms to the electrical
requirements of the machine as
stated on the nameplate.
General Service Information
•
Have the equipment serviced or
repaired at authorized service centres
by qualified personnel only.
•
Replacement parts must be original
equipment manufacturer (OEM) to help
ensure that equipment safety is
maintained.
•
Do not attempt any maintenance or
repair work not described in this
instruction manual.
•
After use, the equipment and
components may still be hot
– allow the
equipment to cool and disconnect spark
plugs and/or electrical power sources
and/or batteries from it before making
adjustments, changing accessories or
performing repair or maintenance.
•
Do not make adjustments while the
equipment is running.
•
Perform all service related activities
under suitable conditions, such as a
workshop etc.
•
Replace any worn, damaged or missing
warning labels immediately.
•
Do not clean equipment with solvents,
flammable liquids or harsh abrasives.
