Fuel-Injected Petrol Powered Inverter Generators
15
Checking and Changing Engine Oil
Always check engine oil level when the machine is in an upright position on a flat and level surface.
• Do not use used or contaminated engine oils. • Use only engine oils of the correct type (see
Specifications
). • Perform the first oil change within the first 20 hours of use. Subsequently, change the oil
every 20 hours of use. • It is recommended that the engine be warm, but not hot, when performing oil
changes. When the oil is warm it drains faster. • Using dirty or incorrect engine oil may cause engine
damage and void any warranty • Always use suitable tools. • Always dispose of used oil in an
environmentally responsible manner and according to regulations. • Some engines feature oil level detection,
which will prevent the engine being started or automatically stop a running engine if there is insufficient oil.
Four-stroke engines require engine oil in the crankcase for lubrication of internal components. Severe or
irreparable damage may occur if the engine is allowed to run without engine oil. The engine oil level requires
regular maintenance as per the maintenance schedule.
To check engine oil level:
1. Place the machine in an upright position on a flat and level
surface.
2. Remove the 2 screws (rotate left) securing the engine access
cover (
A
), and remove the cover.
3. Clean the machine around the oil filler cap (
B
) so that no dirt
or other material enters the engine when the cap is removed.
4. Remove the oil filler cap (rotate left) until fully unscrewed.
The oil level is determined by how far up the dipstick oil can
be seen. To check:
a. Wipe the dipstick (
C
) clean with a piece of cloth or
paper.
b. Insert the dipstick into the oil filler and screw it in.
c. Remove and inspect the dipstick – the MAX oil level
is approximately half way up the patterned section
(
X
).
5. Ensure that the oil level is at or just under the permissible
maximum. If the oil level is low, add additional oil until the
correct level is reached. If the oil level is too high, drain some
oil until the correct level is reached.
6. When finished, reinstall (rotate right) the oil filler cap until
firm. Wipe off any residual oil from the machine.
7. Re-install the engine access cover and secure it with the 2
screws (rotate right).
B
A
C
X