Baumr-AG DRLDICBMRAV30 User Manual Download Page 5

Page: 5 / 10

Electric Core Drill with Base

E&OE

Set-Up and Operation

Ground Fault Circuit Interrupter (GFCI)

The machine MUST be connected to a properly earthed 240VAC mains electrical socket. Do

NOT use the machine with a non-earthed electrical supply. Do NOT use the machine with an

extension cord that is not properly earthed. If there is any doubt regards proper earthing of the electrical

supply, have a qualified electrician inspect and verify it. • If the GFCI green indicator light does not switch off

when

TEST

is pushed, do not use the machine until it is properly tested and repaired. •

If the appliance does

not start, or stops while running, or if you experience an electric shock, switch the machine OFF and

disconnect it from the electrical supply immediately. Do NOT use the machine until it is properly tested and

repaired. • The electrical cable is not protected by the GFCI device from the GFCI device to the electrical

cable plug.

The tool is equipped with a ground fault circuit interrupter (GFCI), which reduces

the risk of electric shock. Check that the electrical mains socket that the machine

is connected to is properly grounded and test the GFCI before each use. To test:

•

Connect the machine into a grounded 240VAC electrical outlet and switch

the power ON.

•

Press the

TEST

button on the GFCI – the green indicator light should switch

off and power to the appliance should cut off.

•

To restore power after testing, push the RESET button.

If the GFCI is tripped due to an earth leakage situation, the power is cut to the

machine, the green indicator lamp switches off and the red warning lamp

illuminates. Switch the machine OFF and disconnect it from the electrical supply immediately. Do NOT use

the machine until it is properly tested and repaired.

Extension Leads

When using an extension lead, ensure it is a 3-wire (grounded) type with wiring of sufficient gauge. The

usage of a smaller gauge wire could lead to excessive overheating of the motor and the cable.

Extension Cord Length (Metres)

>30

AWG 14

AWG 12

Not recommended

Tool Set-Up

Place the motor switch in the "OFF" position and disconnect the machine from the electrical

supply before assembling or making any adjustments to the tool. • Do NOT operate the

equipment with any safety device removed. • Use appropriate personal protective equipment while handling

and using the equipment. • Before use, check for broken, worn, missing, misaligned or binding parts, cable

wear or damage, or any other condition which may prevent safe and normal operation and remedy them

before operating the machine.

The tool is designed for wet drilling into concrete and stone using diamond core bits.
1. Check the appliance and cutting tools for wear or damage. If necessary, replace worn or damaged parts

before using the machine. Dull or damaged cutting tools can lead to binding, breakage, slower cutting

and increased wear and stresses to the tool.

2. Test the GFCI.

BAUMR-AG BAUMR-AG BAUMR-AG BAU