PAGE 7
TP10449
5.0 ELECTRICAL ACCESS
WARNING
Unplug the AC power cord before attempting any
electrical repair.
The motor speed control is located under the left-
hand side cover. The handwheel must be removed for
access to these controls.
The cover can be removed by taking out the four
screws located on the inside of the frame.
6.0 SETUP
6.1 Setting The Controls
The operator controls are conveniently located on a
control panel on the left-hand side of the 714 Friction.
These controls consist of an On/Off power switch,
which is an overload reset, and a speed control
potentiometer.
Set these initially at:
A) Power Switch
Off position
B) Speed Control
“0” position
6.2 Determining Paper Size and Type of Fold
The next step is to determine the paper size and type
of fold to be made, following the steps below:
A) Measure a sample sheet of the job to be run to
determine its size. Retain this information for later use.
B) Refer to the printed chart on the stacker tray (See
Figure 6.2-1) and locate the type of fold that you want to
make. (Example: letter fold)
C) Locate on the chart the columns corresponding
to the sheet size measured in Step A. (Example: 8 1/
2x11)
D) Locate the point on the chart where the columns
for the type of fold and the sheet size intersect. You will
notice that there are either two letters or a dash and a
letter. These letters and/or dash tell you where to set the
paper stop on the fold plate, and whether or not one of the
fold plates will be installed in the deflector position.
Example #1 ; To make a letter fold to an 8 1/2 x11
sheet, set the paper stops for the #1 and #2 fold plates on
the letter E. No dash appears, so neither fold plate is
installed in the deflector position.
Example #2: To make a single fold to an 8 1/2x11
sheet, install the #2 fold plate in the deflector position.
Set the paper stop for the #1 fold plate at the letter K.
6.3 Paper Stop Adjustment
To move the paper stops to the correct position as
determined in step #2, depress the coarse adjustment
knobs on the paper stop and slide the paper stop until the
indicating edge is aligned with the proper letter on the fold
plate. (See Figure 6.3-1)
To obtain an exact setting on the paper stops, turn
the micro-adjustment knobs until the indicating edge of
the paper stop is perfectly aligned with the line adjacent to
the letter on the plate.
Figure 6.3-1
