Baumer PA220, Operating Instructions Manual

Page: 29 / 53

PA220
www.baumer.com
29
Keypad mode (Scaling)
Teach mode (Scaling)
Display stabilization filter
Display intensity
4.2.1 Keypad mode (Scaling)
First measured value
Enter value within the permitted range –1999 to 9999.
Displayed value correlated to first measured value
The entered value appears in the display once the input signal has
achieved the first measured value.
Permitted range:
–1999 to 9999.
Decimal point dSP1
Decimal point position (related to dSP1).
Second measured value
Enter value within the permitted range –1999 to 9999
Displayed value correlated to second measured value
The entered value will appear in the display once the input signal has
achieved the second measured value.
Permitted range: –1999 to 9999.
Decimal point position related to dSP1 is defined.
Configuration of input characteristic
Measured values of non-linear behavior allow for programming of up
to 16 support points (measured and displayed values).
To access programming mode for all measured resp. displayed va-
lues, press key and hold for 3 seconds after having set the se-
cond displayed value. The new entered parameters for the measured
resp. displayed values will be identified by messages [Inp xx] and
[dSP xx]. xx stands for the point number (from 03 to 16).
Measured value xx
Permitted range: –1999 to 9999
Displayed value correlated to measured value xx
The entered value appears in the display once the input signal has
achieved the measured value xx of the previous step.
Permitted range: –1999 to 9999
To interrupt configuration of measured resp. displayed values and
to save the already entered parameters, press 3 s and hold for 3
seconds after having entered the final displayed value.
Important: Mandatory input of measured resp. displayed values in
ascending or descending order.