BAUMATIC
FORMING DROPLETS ON YOUR DISHES
THAT CAN CAUSE SPOTS AND STREAKS. IT
DAMP CLOTH. DON’T FORGET TO REPLACE
THE ‘OPEN’ (LEFT) ARROW AND LIFT IT OUT.
•
POUR THE RINSE AID INTO THE DISPENSER.
DISHWASHER DOOR.
‘OPEN’ ARROW & TURN IT TO THE CLOSED
aid level indicator changes, as illustrated below.
SUPREMA1W/SS dishwasher user manual
7
•
THE RINSE AID IS RELEASED DURING THE
FINAL RINSE TO PREVENT WATER FROM
RINSE AID
ALSO IMPROVES DRYING BY ALLOWING
WATER TO FALL OFF THE DISHES.
•
YOUR DISHWASHER IS DESIGNED TO USE
LIQUID RINSE AIDS. THE RINSE AID
DISPENSER CAN BE FOUND INSIDE THE
DOOR NEXT TO THE DETERGENT
DISPENSER. TO FILL THE DISPENSER, OPEN
THE CAP AND POUR THE RINSE AID INTO
THE DISPENSER UNTIL THE LEVEL
INDICATOR TURNS COMPLETELY BLACK.
THE DISPENSER HOLDS ABOUT 100ML OF
LIQUID RINSE AID.
•
BE CAREFUL NOT TO OVERFILL THE
DISPENSER – THIS COULD CAUSE
•
TO OPEN THE DISPENSER, TURN THE CAP TO
FROTHING. WIPE AWAY SPILLS WITH A
THE CAP BEFORE YOU CLOSE THE
BE CAREFUL NOT TO OVERFILL.
NOTE: IF YOU HAVE SOFT WATER, YOU MAY NOT
•
REPLACE CAP BY INSERTING IT ALIGNED WITH
NEED RINSE AID FOR IT MAY CAUSE A WHITE FILM
(RIGHT) ARROW.
TO DEVELOP ON YOUR DISHES.
ADJUSTING THE RINSE AID DISPENSER
•
As with detergent, the amount of rinse
aid needed for your dishes depends on
the hardness of the water in your area.
Too much rinse aid can result in
foaming and cause cloudiness or
streaks on your dishes. If your water
is very soft, you may not need rinse
aid. You can always dilute the rinse
aid with an equal amount of water.
The rinse aid dispenser has six settings. ALWAYS START WITH THE DISPENSER SET ON “1”. IF SPOTS & POOR
DRYING ARE A PROBLEM, INCREASE THE AMOUNT OF RINSE AID DISPENSED BY REMOVING THE DISPENSER
LID AND ROTATING THE DIAL TO “2”. IF THE DISHES ARE STILL NOT DRYING PROPERLY OR ARE SPOTTED,
ADJUST THE DIAL TO THE NEXT HIGHER NUMBER UNTIL YOUR DISHES ARE SPOT-FREE.
***
NOTE: Please read the notes for detergent use on p. 13.
WHEN TO REFILL THE RINSE
As the rinse aid diminishes, the size of the black dot on the rinse
AID DISPENSER
-
If the rinse aid
Full
warning light (
SEE
control panel) is not on, you
3 / 4 full
can judge the rinse aid level by looking at the
1 / 2 full
black dot on the rinse aid dispenser. As the
1 / 4 full - Should refill to eliminate spotting
rinse aid level decreases, the black dot shrinks.
Empty
Never let the rinse aid get below ¼ full.
7
