Baumatic MEGAWDSS, Instruction Manual

Page: 35 / 40

34
ADJUSTING THE FEET
CAUTION :
o
DO NOT INSTALL YOUR MACHINE ON RUGS OR CARPETS.
o
FOR YOUR WASHING MACHINE TO WORK SILENTLY & WITHOUT ANY VIBRATION, YOU
SHOULD POSITION IT ON FLAT, NON-SLIPPERY & TOUGH GROUND.
o
YOU CAN ADJUST YOUR WASHING MACHINE’S LEVEL BY TURNING ITS FEET EITHER
UPWARDS OR DOWNWARDS (Please see DIAGRAM below).
1) FIRSTLY, LOOSEN THE PLASTIC
ADJUSTMENT NUT.
2) AFTER YOU’VE REACHED THE
LEVEL YOU WANT, TIGHTEN THE
PLASTIC ADJUSTMENT NUTS
AGAIN BY ROTATING THEM
UPWARDS (ONE FOR EACH
FOOT).
3) NEVER PUT CARTONS, WOODEN
BLOCKS OR SIMILAR MATERIALS
UNDER THE MACHINE TO HELP MAKE
IT LEVEL TO THE GROUND.
4) NOTE: THE HIGHEST YOU CAN RAISE
THE APPLIANCE ON ITS FEET IS
30mm.
__
_______________________________________________________
ELECTRICAL CONNECTION
YOUR WASHING MACHINE WORKS ON 220-240V & 50 Hz. IT COMES WITH ITS OWN
SPECIALLY MOULDED, EARTHED PLUG THAT HAS BEEN ATTACHED TO THE POWER
CABLE OF YOUR WASHING MACHINE. The plug must be inserted to an earthed socket
with 10 ampere. The fuse used in your plug must also be 10Amps. Should your electricity
supply not match these specifications, you should contact a qualified electrician to
accommodate this.
*REMINDER: WARNING! (PLEASE NOTE) Baumatic Ltd are not responsible for any
damages arising out of usage following failure to earth (ground) your appliance.
CONNECTING TO THE WATER MAINS
•
Depending on your
appliance’s features, it may
operate with a single water
inlet (cold) or a double water
inlet (hot/cold). THE WHITE-
HEADED HOSE IS FOR
THE COLD WATER INLET /
THE RED-HEADED HOSE
IS FOR THE HOT WATER
INLET (but ONLY for
machines with a double
water inlet system).