Baumatic FG65, User And Installation Instructions Manual

Page: 14 / 20

INSTALLATION INSTRUCTIONS
MAINTENANCE
Refer back to the retailer the hob has beeen purchased from.
Please note that intervention or repair by any unauthorised personnel will invalidate
any warranty.
Before carrying out any maintenance, disconnect the appliance from the gas and
electricity supplies.
If a gas tap becomes stiff to operate, proceed as follows:
• Remove the control knobs, pan supports, burners and hob fixing screws & clamps.
• Remove the Hob from the worktop and remove any underside protective covers.
• Disconnect the fixings holding the tap to the fascia panel, separate the assembly, then
clean the cone and seating with a cloth dampened with solvent.
• Lightly smear the cone with high temperature grease, reassemble into position and
rotate a few times. Remove the cone again and remove any excess grease making
sure that the gas ducts are not obstructed with grease.
• Carefully reassemble the components and check for gas soundness.
If it becomes necessary to replace the gas tap, proceed as follows:
• Disconnect the appliance as described above.
• Disconnect the gas pipe from the gas tap, disassemble from the gas rail by removing
the fixing screws.
• When fitting a new tap, ensure that a new gasket is used.
• Re-connect the gas tap, check for gas soundness and reassemble the hob.
TECHNICAL DATA
ELECTRICAL DETAILS
Rated Voltage 230V ac 50Hz
Supply Connection 13A (double pole switched fused outlet with 3mm contact gap)
Power Input 0.008 to 0.02kW (depending on model)
Mains supply lead 3 x 0.75mm2 Type RR-F <HAR> marked
GAS DETAILS
Connection Rp ½ (ISO R7)
Type Gas 20-1 kPa – alternative LPG G30 (28-30 mbar)
12