Baumatic BWD1206SL-W, User Manual

Page: 33 / 36

33
100 cm.
o
Make sure the drain
hose is not in water.
Drainage failure.
o
Drain hose is blocked.
o
Drain hose end is more
than 100 cm above the
floor level.
o
The filter is blocked.
o
Unblock the drain
hose.
o
Make sure the drain
hose end is less
than 100 cm above
floor level.
o
Unblock the filter.
Strong vibration
while spinning.
o
Not all transportation bolts
have been removed.
o
Washer-dryer is located on
an uneven floor surface or
is not level.
o
Machine is overloaded.
o
Check if all
transportation bolts
have been removed.
o
Make sure the
washer-dryer is on
an even surface and
leveled.
o
Reduce amount of
laundry in the drum.
Operation stops
before completing
wash cycle.
o
Water or electricity failure.
o
Check the power
supply.
Operation stops
for a period of
time.
o
Washer-dryer gives an
error message.
o
Wait until cycle is
complete.
o
See display codes
on previous page.
Excessive foam in
the drum.
o
The detergent is not a low-
foaming type or for manual
wash.
o
Excessive use of detergent.
o
Check if your
detergent is
appropriate.
o
Reduce amount of
detergent used.
Automatic
adjustment of the
washing time.
o
The washing program
duration will be adjusted
according to the initial
water temperature.
o
This is normal and
does not affect the
functionality.
Spinning fails.
o
Unbalance of the laundry.
o
Add clothes or run a
spinning program
again.
IMPORTANT: Your appliance has an unbalance control system. If this
system detects that the washload is unevenly distributed inside the
drum. Your washing machine will try to redistribute the load before
spinning. If after several attempts it is unable to redistribute the
washload, then the appliance will either spin at a slower speed or skip
the spin cycle and proceed to the drain section of the wash cycle.
Uneven load distribution can be caused by too large a wash load or too
small a wash load. It can also occur if a single item if washed inside
the appliance.