162579
You control the freezer’s interior temperature automatically by
setting the thermostat. This can be found on the control panel at
the bottom of the freezer.
• The most suitable position is in the middle between max. (7) &
min. (1).
• We recommend setting the thermostat on a position
approaching maximum (7) only to accelerate cooling (e.g.,
before loading smaller amounts of fresh foods or when the
operation mode has risen to the ambient temperature).
• Thermostat settings towards min. (1) help you save energy,
provided that the freezer is loaded with a smaller amount of
frozen foods.
• Changes in the ambient temperature will affect the
temperature in the interior of the appliance.
• Choose the correct setting using the thermostat knob (pictured
below).
• Switch the freezer on.
• The sound alarm will come on because the temperature will be
too high. It is designed to activate when exposed to this. THIS
IS NORMAL. You switch the alarm off by pressing the alarm
button:
• On the control panel, switch to the continuous operation
position. All three signal lamps will light up. Place fresh food
into the freezer several hours after the red signal lamp has
gone off.
• 24 hours before you place fresh food in the freezer, switch the
continuous operation button (‘2’ in Figure on page 7) on (i.e.,
so that the yellow lamp comes on). At the end of this period,
load fresh food into the freezing compartment (the topmost
compartment of the freezer).
• After 24 hours, move the frozen food to the storage
compartment of the freezer and repeat the freezing procedure
with a new load, if required.
• REMINDER - fresh food should not touch those packages that
are already frozen.
USING YOUR FREEZER
• Approximately 24 hours after the last loading of fresh food into
your freezer, press the continued operation button again (‘2’ in
Figure on page 7) so that the freezer switches to its automatic
operation (yellow light turns off).
Proper Freezing Procedure
9
Temperature Selection
Using Your Freezer
Starting Your Freezer
For The First Time
(* After It Has Been
Installed)