7
Follow the instructions below to complete a
pyrolytic cleaning cycle:
IMPORTANT: Remove all accessories (trays,
grills, tray side supports, tele-
scopic guide rails) from inside the oven.
1.
Ensure all major food residues are remo-
ved from the oven and thoroughly clean the
inner door glass.
2.
Turn the cooking control dial to the Pyrolytic
position
. You will hear a beep which
confirms this function has been chosen.
3.
You will then see a P (pyrolytic programme)
on the timer display together and the
symbol will
flash.
4.
Press the + or – sensors to select one of
the pyrolytic programmes (P1, P2 or P3).
P1: Minimum programme (lasts 1 hour).
P2: Standard programme (lasts 1.5 hours).
P3: Maximum programme (lasts 2 hours).
5.
After a couple of seconds, you will hear 2
beeps confirming the pyrolytic programme
chosen.
6.
After a shor t time, the pilot light
will turn
on and the oven door will be locked.
7.
The oven will star t to heat up and the
symbol
will appear permanently. The
timer display will show the time remaining
until the end of the programme.
IMPORTANT:
At this point, the oven is pro-
grammed and the pyrolitic cleaning cycle is
under way. During the cycle, none of the oven
timer functions may be chosen. Do not tr y to
open the oven door as this may interrupt the
cleaning process.
8.
When the pyrolytic cleaning cycle has
finished, an alarm will sound and the
symbol will
flash.
9.
Press any of the timer keys to turn the
alarm off. The symbol
will disappear.
10.
Turn the cooking control dial to the posi-
tion .
11.
Although the oven’s heating process has
ended, it is extremely hot and cannot be
used. The cooling motor will operate until
the oven cools down and the pilot light
will remain on.
IMPORTANT
The cooling process may last up to 2 hours
because of the high temperatures inside the
oven.
12.
Once pilot light
has turned off, you will
soon be able to open the oven door.
IMPORTANT
To open the door (pilot light
on), the control
dial must be in position
. If you did not
follow step 10, set the control dial to position
and wait a few minutes until the door
unlocks and the pilot light turns off.
13.
Open the oven door and wipe the inside
with a damp cloth, cleaning up the ash
from the cleaning cycle. Hard-to-reach
areas in the oven will need to be cleaned
with a non-metallic fibre scourer.
14.
Once the oven is clean, remember to
replace the suppor ts and accessories.
15.
The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section “Incidents while
Operating the Pyrolytic Function”.
PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
