11
Initial set-up of your oven
Selecting manual operation mode
After your appliance is connected to your mains supply for the first
time (or after a power-cut) the numbers on the timer display will flash.
manual operation mode, press the program button (12)
oven in use symbol (15) will light in the
e of day. Whilst
e
and wait a few seconds. The decimal
16) will stop flashing and the oven is ready to use.
from
s cooled, it should then be cleaned with
warm soapy water, using either a sponge or soft cloth. No abrasive
cleaners should be used.
Before you can select a cooking function or set a temperature, you
must set the appliance into “manual operation” mode.
To select
o
for three seconds. The
display.
Setting the time of day
After your appliance is connected to your mains supply for the first
time, you must set the time of day before you can use the oven.
o
Make sure the oven is in manual operation mode (as outlined
above).
Press the program button (12) once to set the tim
o
the decimal point symbol (16) is flashing, use the plus (13) and
minus (11) buttons to set the correct time of day.
When the correct time of day is shown on the LED display, releas
o
the plus and minus buttons
point symbol (
Before first use
To remove any residue from the oven that may have been left
o
the manufacturing process, you should select the fan oven function
and set the thermostat to its maximum temperature setting.
o
It is perfectly normal for a smell to be produced during this process.
o
You should make sure that any windows in the room are left open
during this process.
o
It is advisable for you not to remain in the room whilst the burning
off process is taking place.
o
You should leave the oven on maximum setting for 30 – 40
minutes.
After the oven cavity ha
o
