7
After connecting the appliance, turn on all cooking zones / heaters for approximately three
minutes to make sure they are operating correctly.
Connecting
Incorrect connection may destroy parts of the appliance, making the warranty void.
Connection cable on the back of the appliance should be led in such way that it does not
touch the appliance back wall, as this part will get very hot during operation.
The following cables can be used for connection:
H05RR-F
H07RN-F
H05V2V2-F
LIVE L
BROWN
EARTH
YELLOW / GREEN
NEUTRAL N BLUE
CONNECTING TO THE GAS SUPPLY
Connection to the gas supply, or conversion from one type of gas to another, should only be undertaken by an approved
and registered gas installer in strict accordance with local and national safety and building regulations.
Check with your local gas supplier about the type of gas and its calorific value, and compare this information with the
type of gas quoted on the cooktop data plate.
This appliance is not suitable for connection to a burning fumes exhaust system (i.e. a chimney).
WARNING
: Special care must be taken to ensure adequate ventilation / aeration (
a
= min. 100 cm
2
). The gas cooking
appliance use may cause heat, humidity and products of combustion in the room where is installed. Ensure that the
kitchen is well ventilated especially when the appliance is in use: keep open any natural ventilation holes or install a
mechanical ventilation device (mechanical extractor hood). Prolonged intensive use of the appliance may call for
additional ventilation, for example opening of a window, or more effective ventilation, for example increasing the level of
mechanical ventilation where present.
Connection
When connecting the appliance to the gas supply, follow the regulations of the local gas
distributor.
On the lower side, the cooking hob is fitted with a gas connection plug with a thread.
When connecting, the knee should be held firmly to prevent it from rotating.
For sealing of the connection joints, use a non-metal approved gaskets and approved
sealants.
The gaskets should only be used once. The thickness of the flat non-metal gaskets should
not be deformed more than by 25 percent.
To connect the appliance to the gas supply, use a tested and certified flexible hose.
The flexible connection hose should be able to move freely. It should not come into contact
with the movable parts of the furniture or the bottom of the cooking hob.
If an electric oven is built into the kitchen element under the cooking hob, it should be fitted
with a cooling fan.
After connecting the gas hob, check the joints for any leaks.
A
ISO7-1 R1/2 (or ISO 228/1) connection plug
B
Non-metal gasket with thickness of 2 mm
C
Pipe adapter for liquid gas (depending on the model)
Only use pipes and seals in accordance with the Standards
. These pipes must be
installed so that, when fully extended, their length does not exceed 2000 mm. For easier
installation and to prevent gas leaks, attach the swivel coupling to the cook top first, and
then to the gas mains pipe. Inverting this sequence may hamper the gas seal between the
