29
This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
Please refer to the conditions of guarantee that appear on the
warranty card that you receive with the appliance.
IMPORTANT: Baumatic Ltd. operates a policy of continuous
improvement and reserves the right to adjust and modify its
products without prior notification.
General troubleshooting
Category
Problem
Possible causes
What to do
Fuse blown or the
circuit breaker
acted.
Replace the fuse or reset the
circuit breaker. Remove any
other appliances sharing the
same circuit with the
dishwasher.
Power supply is not
turned on.
Make sure the dishwasher is
turned on and the door is
closed securely.
Make sure the power cord is
properly plugged into the
wall socket.
Water pressure is
low.
Check that the water supply
is connected properly and
the water is turned on.
Dishwasher
does not
start.
Door of dishwasher
not properly
closed.
Make sure to close the door
properly and latch it.
Kink in the drain
hose.
Check the drain hose.
Filter is clogged.
Check the coarse filter.
Technical
problems
Water not
pumped
from
dishwasher.
Kitchen sink is
clogged.
Check the kitchen sink to
make sure it is draining well.
If the problem is in the
kitchen sink and not the
draining, you may need a
plumber rather than an
authorised service agent.
Improper detergent
used.
Use only the specific
dishwasher detergent
amount to avoid suds. If this
occurs, open the dishwasher
and let the suds evaporate.
Add 1 gallon of cold water to
the tub. Close and latch the
dishwasher door then start
the SOAK wash cycle to
drain out the water. Repeat
if necessary.
Suds in the
tub.
Spilled rinse-aid.
Always wipe up rinse-aid
spills immediately.
General
problems
Stained tub Detergent with
Make sure that the
