o
Apply the sealing strip provided around the edge of the appliance.
o
Do not leave a gap in the sealing strip or overlap the thickness.
IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob from
the aperture in future, particularly if it needs to be serviced.
o
Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o
On the underneath of the hob, place the
clamp(s) (B) into position on in each
corner of the hob.
o
Adjust the clamps into a position that is
suitable for your worktop, as shown in
the diagrams on the left.
o
Slightly tighten the screw (C) through
each clamp (B) so that the clamp is
attached to the hob.
o
Once you are satisfied of the position of
the hob, you can fully tighten the screws
(C) to secure the hob into position.
32
Summary of Contents for BHI909TS. GWK
Page 1: ...1 BHI909TS GWK 90cm Induction Gas Hob ...
Page 45: ...45 ...
Page 46: ...46 ...
Page 48: ...48 ...
