o
Apply the sealing strip provided around the edge of the
appliance.
o
The protective covering must be removed from both sides.
o
Do not leave a gap in the sealing agent or overlap the thickness.
o
IMPORTANT:
Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be
serviced.
(A)
Clip
(B)
Fixing
bracket
(C)
Screw
o
You should insert a clip
(A)
into the holes which are located in
each corner of the hob.
o
Place the fixing brackets
(B)
over each hole and clip, and then
place a screw
(C)
through the hole and fixing bracket
(B)
.
Tighten the screws a little way, so that they stay in place.
IMPORTANT:
Do not tighten the screws fully.
o
Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o
On the underneath of the hob,
locate the fixing brackets
(B)
and
turn them so that they locate on
the underneath of the worktop
and the hob.
o
Fully tighten the screws
(C)
to
secure the hob into position.
17
Summary of Contents for BHC601
Page 1: ...1 BHC601 60cm 4 Radiant zone frameless ceramic hob...
Page 23: ...23...
Page 24: ...24...
