26
Fitting the chimney
If you have purchased the BECW600 or BECW900, then you should fit
the chimney sections that are supplied with these models. For the
sloped cooker hoods, no chimney sections are supplied, however you
can purchase the CQ5SS chimney sections as an optional extra.
18)
Locate the lower chimney section into the gap at the top of
the cooker hood body, with the upper chimney section sitting
inside of it.
19)
Place the flat bracket into the keyhole slots at the top of
the lower chimney section. Mark out the position of the two
screw holes in the flat bracket.
20)
Raise the upper chimney section until it reaches the
ceiling. Place the L shaped bracket against the wall, ensuring
that the holes in it line up with the holes in the top of the
upper chimney section.
21)
Mark out the position of the two screw holes in the L
shaped bracket.